Enable Adaptive Response Agents

The preconfigured agents are created on your PacketShaper, iShaper, or PolicyCenter configuration when you first enable the adaptive response feature. All preconfigured agents are disabled by default, and you need to decide which ones you want to use and enable the ones that look most useful. Once an agent is enabled, adaptive response will begin monitoring the variables and reporting scores associated with the agent.

Note: To perform this task from PolicyCenter, you must first select a unit or draft configuration in the Configurations window. Then select the Setup tab from the right pane of this window, and proceed to step 2 of the procedure below.

To enable AR agents:

1. Click the setup tab.
   
   
2. Choose adaptive response from the Choose Setup Page list, or click the Adaptive Response Settings link.
   
   
3. For each agent you want to enable, click the checkbox in the Agent On column.
   
   
4. Click apply changes.

Note: The preconfigured agents are only created when there are no custom or predefined agents currently on your PacketShaper, iShaper, or PolicyCenter configuration. If you delete a preconfigured agent, toggling the adaptive response setting off and then on again will not recreate that agent unless all agents are also removed.

See also:

Agents Overview